Furrion Cameras Constantly Stay On Even When Unhooked With Grand Design Trailer Pre-wired For Camera

Question

Question:

I have a grand design solitude and purchased the furrion vision s model #fce48tasl . The rv is prewired for these cameras. I installed them and they stay on all the time. Can you help me with that? Forgot to mention that they stay on after I unhook .

asked by: Michael G

1

Helpful Expert Reply:

This seems to be a common issue with the Furrion cameras like part # FCE48TASL in the Grand Design trailers according to my research because of the way the pre-wired system was set up. Since your trailer was pre-wired for the camera then it is receiving power from the 12V power source on the trailer and not the running light circuit. Normally when the cameras are wired aftermarket the cameras are just wired to the running lights so they only work when the running lights are activated. If the cameras are on even when you unhook the trailer then Grand Design has the pre-wired wires connected to the the constant power source on your trailer like the battery.

I recommend to take the trailer to the dealership to have them trace the wiring to the power source.

expert reply by: Heather A

1

Answer 1

I recommend replacing your hoses with the GasGear 90-Degree Propane Hose #GS47FR. Not only does this hose have a stainless steel braded hose which is less likely to stiffen and crack over time, the hose has a 90 degree fitting which relieves the hard…

view full answer...

Answer 2

Thanks for the photos! Yes, the MB Sturgis Propane Pigtail w/ Back Check #100575-12-MBS has the connections needed for both the regulator and the propane tank on your 2021 Grand Design Imagine 22MLE travel trailer. If you wanted to get a pigtail…

view full answer...

Answer 3

Hey, Brian. From your message, it sounds like you already have brackets for the Furrion side marker lights with the built-in camera. If you’re only needing the side marker lights themselves, Furrion does offer those separately as part #FCE48TASL. If…

view full answer...

Answer 4

Hey John, the Dexstar Mini Mod Wheel part #AM20757 that you referenced can be used with your GM air pressure sensor but you would need to use an adapter kit to allow it to fit the larger hole size than what your sensor fits. The sensor fits the hole…

view full answer...

Answer 5

I contacted Trimark in regards to a replacement part for the Trimark 030-0900. 030-0900 is actually a series number not a specific part number. To find the part number you will need to take the interior handle completely off the unit. On the back…

view full answer...

Answer 6

Hey Robert, I would check to see if something happened to the antenna on the camera if this is a new problem. It's possible it's not pointing up anymore and fixing that will get you back the reception you once had. Let me know if that helps…

view full answer...

Answer 7

Hey Randy! The intent is to swap out the entire assembly. The side cameras are not available separately without the light attached. Also, I would get the new Furrion Vision S+ since the old system won't be around much longer and neither will the…

view full answer...

Answer 8

Since you're powering the Furrion Vision S RV Camera System #FCE48TASL-05 off of the trailer battery instead of the tow vehicle it wouldn't be a PWM wiring issue like you're suspecting. Where exactly do you have the trigger wire ran to?…

view full answer...

Answer 9

Hey Dave, congrats on the new truck and trailer. You're definitely going to want the extra clearance an offset gooseneck ball provides with a 6-3/4' bed. The Gen-Y gooseneck pin boxes do not help with turning clearance. For your 2026 Chevy…

view full answer...

Furrion Cameras Constantly Stay On Even When Unhooked With Grand Design Trailer Pre-wired For Camera

Product Page this Question was Asked From

Continue Researching