Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Since the GM TPMS uses a proprietary software so you aren't going to be able to use another sensor with the program even if they operate on the same frequency. So, with that being said, your best option is to use a standalone system like the TST…
view full answer...I can confirm for you that the B&W Tow & Stow 2-Ball Mount will fit a factory 2-1/2" trailer hitch receiver on a 2020 Ram 3500. This has capacities of 7,500 lbs with the 2" ball or 18,000 lbs with the 2-5/16" ball, and a…
view full answer...It is true that the InfiniteRule Locking Pins for B & W Tow and Stow Ball Mounts #34061775-D are only listed for the 10K and 14.5K. However, we have confirmed that these will also work for the 18K models like the #BWTS20040C so this is the…
view full answer...To lock the BulletProof Hitches 2-Ball Mount for 2-1/2" Hitch #HD254 to your hitch receiver I recommend the InfiniteRule Hitch Lock #34061072-D, but if you're interested in locking the platform to the ball mount as well then you'll want…
view full answer...Yes, MORryde cushioned pin boxes like #MR84VR can be used with Demco Hijacker Autoslide fifth wheel hitches. There's even a capture plate from MORryde that was designed for this application with the part #DM6025.
view full answer...You will want a slider hitch like you mentioned to prevent the nose of your trailer from hitting the cab of your 2019 Ford F-350 since you have a short bed truck. The slider hitch allows the pivot point to move back and give you the needed clearance.…
view full answer...A chrome finish ball #C40036 is going to look good but it will not be corrosion resistant. A ball with a machine finish like #C40087 , is going to have about the same corrosion resistance. In terms of performance they will wear at about the same rate…
view full answer...What you need is the Replacement RV Air Conditioner Cover for Penguin and Dometic Air Conditioners #AT3308046006. This is the correct shroud for your Dometic 600312.321.
view full answer...Are you sure the camera has power ran to it when the running lights are on? Can you test the power wire for it and also make sure the ground is good? There should be a pair button on the bottom of the camera that you can hold down which will put it…
view full answer...90-95 ft lbs of torque is probably about right for your trailer rims. If you check out the lug nut torque chart that I attached you will see that nearly all of the torque specs are that and higher.
view full answer...Hey Ben, the Rear View Safety Wireless Backup Camera System #RVS-4CAM you're looking at will work just fine with your steel motorhome. This camera system would only have an issue if your motorhome was made of aluminum. This system also has a…
view full answer...To use the Curt Echo Wireless Trailer Brake Controller #C51180 your vehicle only needs 12 volt, ground, and turn signals connected to its 7-way socket. What this means is you do not need the brake signal from the 7-way. For example, if you used a…
view full answer...Related Searches
Filter Your Search
Contact and Help