Front Hitch Installation On 2011 Toyota Tacoma
Updated 09/19/2019 | Published 09/18/2019
Question:
printed instruction for installation. do not see any holes in the frame of the truck. could they be plugged with plastic fittings ?
asked by: Paul S
Expert Reply:
I contacted Curt on your behalf and they confirmed for the Curt Front Mount Trailer Hitch Receiver # 31313, the side carriage bolts should be replaced with the installation kit bolts and there shouldn't be plastic fittings to remove there. For 2 wheel drive model Tacomas however there may be a need to drill the holes from the bottom up - reference the diagram on page 1, (TYP) (2WD Only) in the instructions for these specific holes. If that is where you're referring to then there will be no plastic fittings to remove.
If you have additional questions from here I'm happy to help.
Product Page this Question was Asked From
Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Front Receiver Hitch
- Visible Cross Tube
- 350 lbs Vert Load
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Draw-Tite Front Mount Hitch on 2014 Toyota Tacoma
- Q&A: Air Bag And Gooseneck Hitch Compatibility For A 2012 Toyota Tundra
- Q&A: Which Air Bags Are Compatible with a B&W Gooseneck Underbed Installation Kit on 2019 Toyota Tundra
- Q&A: Removing Skid Shield to Install Front Mounted Receiver on 2014 Toyota Tacoma
- Q&A: Will Firestone Air Springs Fit A 2020 Toyota Tundra With A B&W Turnoverball Gooseneck Hitch
- Q&A: Are Firestone Air Bags Compatible With B&W Gooseneck Hitch on 2019 Toyota Tundra
- Q&A: Air Bag Helper Springs Compatible With B&W Turnover Ball Gooseneck Hitch 2018 Toyota Tundra CrewMax
- Article: Trailer Wiring Diagrams
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Troubleshooting 4 and 5-Way Wiring Installations