How Does Jensen Pull Up AN110 Antenna Mount
Updated 09/18/2019 | Published 09/17/2019
Question:
size hole needed and how to mount ? no directions with antenna
asked by: Edward S
0
Expert Reply:
The Jensen Pull Up Antenna part # AN110 comes with a mounting bracket and self tapping screws. It does not fit into a hole. I have attached a photo for you to see what I mean. You would use the screws to attach the bracket to what you are using it for.
expert reply by:
Heather A
0
click to enlarge
Product Page this Question was Asked From
Continue Researching
- Shop: Jensen Pull Up Antenna - Top Mount
- Video: A Closer Look at the Jensen Pull Up Antenna
- Q&A: Is A Regulator Needed For A Trailer's Propane System If There's Already One On The Stove
- Q&A: How to Replace a Lance 6-Pin Plug w/ a Standard 7-Way Connector
- Q&A: Which Dometic SmartStart Fits Dometic Penguin II AC With Manual Controls Under Vent Assembly
- Q&A: Replacement For Duo-Therm 57915.622 Air Conditioner on Travel Trailer
- Q&A: Parts Needed To Add a 7-Way To a 1999 Ford E-350 15 Passenger Van With Factory 4-Way
- Q&A: Is There a Replacement Mounting Bracket Available For a Furrion FOD43TA-BL Monitor
- Q&A: What RV Antennas Have a Rubber Mast/Mount?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How Does an RV Water Pump Work?
- Article: What are the Common Types of Propane Fittings Used on RVs?