Required Spacing to Install Blue Ox Bracket Kit BX88230 on Jeep Wrangler JK
Updated 09/17/2019 | Published 09/15/2019
Question:
How far apart from each other should the brackets be on the front bumper of a jeep wrangler JK?
asked by: RICHARD J
0
Expert Reply:
According to the installation instructions, the brackets for # BX88230 require a spacing of 21-1/8 inches.
You will first locate the center of your bumper and measure out 10-1/16 inches to either side, then from the center of each mark, measure over 21-1/8 inches to the opposite side to drill the 17/32 inch holes.
I have included a link at the bottom so you can access the complete installation instructions.
expert reply by:
Carla M
0
Product Page this Question was Asked From
Blue Ox Universal Bolt-On Base Plate Brackets - 5,000 lbs
- Accessories and Parts
- Tow Bar Base Plate
- Brackets
- Blue Ox
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommended Baseplate Kit for a 1974 VW Super Beetle
- Q&A: Base Plates and Recommended Flat Towing Accessories for 1978 Volkswagen Beetle Convertible
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Attaching Tow Bar to 2010 Jeep Wrangler With Rugged Ridge Bumper
- Article: Flat Towing Package for 1997 Jeep Wrangler
- Q&A: Installing Old Tekonsha Weathertronic Electric Brake Controller
- Q&A: Can Trailer Tire Sizes be Mixed To Avoid Purchasing 4 New Tires Together
- Q&A: Will etrailer Classic Base Plate Kit Work With Roadmaster or Blue Ox Tow Bars
- Q&A: What gauge wire is recommended when installing Pollak 7 way trailer connector?
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: Flat Towing Package for 2007-2018 JK Jeep Wrangler and Wrangler Unlimited
- Article: Brake Controller Installation: Starting from Scratch
- Article: What Is a Supplemental Braking System?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)