Winch Wiring Kit for Installing Viper Recovery Winch on Trailer from Tow Vehicle Battery
Published 09/13/2019
Products Featured in This Question
Question:
What size wire do I need to wire up a VX10000 Viper Recovery. From the truck battery to the winch mounted on the trailer. Thanks
asked by: Wesley W
Expert Reply:
While we don't carry Viper brand winches I was able to determine that they were designed to be used with 2 gauge wire. But since you are going to have a longer cable setup I'd recommend a thicker gauge to offset the increased length. So for that I would recommend the # BDW20348 for a section of 24 foot long 1 gauge wire for the vehicle side of the wiring and then for the trailer side we have the # BDW20347 which is 7-1/2 feet long and also 1 gauge.
Product Page this Question was Asked From
Bulldog Winch Rear Wiring Kit - Quick Connect to Terminal End - 1 Gauge - 24' Long
- Accessories and Parts
- Electric Winch
- Wiring
- Quick Connects
- Wiring Kits
- 1 Gauge Wire
- Bulldog Winch
more information >
Continue Researching
- Q&A: How To Choose Correct Size Wire for 12K Winch on Rear of Vehicle
- Q&A: Can 7-Way Trailer Connector Accessory Circuit be Used to Power Trailer-Mounted Winch
- Q&A: What Gauge Wire is Needed for Trailer Winch
- Q&A: High Amperage Quick Disconnect Setup for Back of Tow Vehicle to Trailer
- Article: Which Hitches are Made in the USA
- Q&A: Recommended Front Mount Hitch For A 2020 Chevrolet Silverado 2500
- Q&A: Does EcoHitch Front Hitch Fit 2020 Chevy Silverado 1500 & Is Install Easy
- Q&A: Will the EcoHitch Front Receiver Fit a 2020 Chevy Silverado LT Trailboss with 5.3L Gas Engine?
- Article: How to Wire an Electric Winch