Jack Stand Placement To Suspend Trailer for Storage
Updated 09/11/2019 | Published 09/10/2019 >
Question:
I have a 12foot tandem axle utility trailer and I want to store it using 4 jack stands. Where should I place the jack stands? Under the axles near the springs and use the front jack to level? - or one jack stand near each corner of the trailer?
asked by: Kent L
Helpful Expert Reply:
You were on the right track. To raise the tires off the ground for long term trailer storage, the best way is to use your front jack to raise the trailer then place the jack stands under the frame by each axle on all four sides. I have attached a photo for reference.
Since the # PTW41021 are sold in pairs, you will need to purchase two for a total of four stands.
Product Page this Question was Asked From
Vehicle Jack Stands - 10-3/4" to 16-3/4" Lift - 2 Tons - Qty 2
- Automotive Tools
- Jack Stands
- Jacks and Jack Stands
- 2 Tons
- Performance Tool
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Trailer Hub and Drum Assembly - 3,500-lb Axles - 10" Diameter - 6 on 5-1/2 - Pre-Greased
- Search Results: trailer hubs and drums
- Search Results: 6 on 5~1/2 inch trailer hubs and drums
- Search Results: 6 lug idler
- Search Results: 6k bearing kit
- Shop: Trailer Idler Hub Assembly for 6,000-lb Axles - 6 on 5-1/2 - Pre-Greased
- Q&A: Replacing Wiring on Old Livestock Trailer with Electric Brakes
- Shop: Trailer Hub and Drum Assembly - 5,200-lb and 6,000-lb Axles - 12" - 6 on 5-1/2 - Pre-Greased
- Shop: Dexter Electric Trailer Brakes - 12" - Left/Right Hand - 6K AL-KO/Hayes Axles
- Shop: Easy Grease Trailer Hub and Drum Assembly for 6K Axles - 12" - 6 on 5-1/2 - Galvanized
- Shop: Vehicle Jack Stands - 10-3/4" to 16-3/4" Lift - 2 Tons - Qty 2
- Article: Trailer Lighting Requirements
- Video: Comprehensive Review: Demco Trailer Brake Mounting Flange
- Video: In-Depth Review of the Easy Grease Trailer Hub and Drum Assembly for 6K Axles
- Q&A: How to Rewire an Old Cattle Trailer
- Q&A: Looking For Brakes For Kelsey Hayes/AL-KO 12"x2" Brakes
- Q&A: Recommended Brake Assembly 12x2 with 4 Bolt Mounting Pattern
- Q&A: Looking For Replacement Trailer Axles With 70 Inch Spring Center and 85 Inch Hub Face Spacing
- Q&A: Available 12 x 2-Inch 6K-Rated Electric Trailer Brakes with 4-Bolt Mounting Pattern
- Q&A: Can Brakes be Installed on Only One of the Axles of a Tandem Axle Trailer
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Video: Easily Install Your Redarc Tow-Pro Link Bluetooth Brake Controller - 2023 Jeep Gladiator
- Video: Camco FasTen RV Leveling Blocks with Carrying Handle Manufacturer Review
- Search Results: jack stands
- Search Results: trailer legs
- Search Results: curt spectrum brake controller
- Video: Installing the Curt T-Connector Vehicle Wiring Harness on a 2023 Volvo XC90
- Video: Installing the Autowbrake Electric Brake Controller
- Video: How to Set Up Your Stealth Hitches Hidden Rack Receiver on a 2016 Volvo XC90



