Replacement Strut For UWS Tool Box With Automatic Lift
Updated 09/11/2019 | Published 09/09/2019
Products Featured in This Question
Question:
I have a UWS toolbox and the strut is broken can i replace it or do I have to get a whole new box?
asked by: Bart S
0
Expert Reply:
Yes you can replace the gas strut lift cylinder of your UWS toolbox with part # UWSLIFTCYLIND. If you need the ball stud as well, you can use part # UWSBALLSTUD.
expert reply by:
Heather A
0
Product Page this Question was Asked From
UWS A-Frame Trailer Toolbox - 6.3 cu ft - Bright Aluminum
- Trailer Tool Box
- A-Frame Tool Box
- 19 - 22 Inch Tall
- Aluminum
- 41 Inch and Longer
- Silver
- UWS
more information >
Continue Researching
- Q&A: Front To Back Measurement On Buyers Products Trailer Tongue Toolbox
- Q&A: Can I Put Four 6 Volt Batteries in the Buyers Products Trailer Tongue Toolbox 3371701385?
- Q&A: Recommended Trailer Tongue Tool Box to Hold Two Propane Tanks
- Q&A: Will Hydrastar Disc Brake Kit HYD44VR Fit Tandem Axle Trailer with 6k Axles
- Q&A: Gauge/Thickness of Aluminum Used on UWS Tool Box # UWS01039
- Q&A: Mounting the Aluminum A-Frame Trailer Tongue Toolbox to the A-Frame of The Trailer
- Q&A: Confirming If ARK Xtreme Off-Road Swing-Up Jack will Fit a Trailer With 6.75 Inches Clearance To Box
- Article: How to Measure for Trailer Hitch Drop
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Maintenance Schedule
- Article: Trailer Wiring Diagrams
- Article: Still Rocking After Leveling? How to Stabilize Your RV for Good
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)