How Does Atwood Water Heater Switch # AT91959 Get Wired
Updated 09/10/2019 | Published 09/09/2019
Question:
i bought an atwood 91859 on/off switch to go with my propane g6a-8e water heater its a used 28f four winds 2006 mdl the wires coming out the wall are one red, three white, two green, and one brown took the old switch out without marking where they go and i need to know what pins on the switch these wires go. thanks
asked by: Butch B
0
Expert Reply:
I attached a wiring diagram that shows how the Atwood water heater switch part # AT91959 gets wired up. Since your water heater is the G6A-8E you'd need to use the middle diagram.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
Replacement Single-Panel On/Off Switch for Atwood Gas and Electric Water Heaters - Black
- Accessories and Parts
- RV Water Heater
- Switches
- Black
- Atwood
more information >
Continue Researching
- Q&A: Wiring Diagram for Dometic RV Water Heater
- Q&A: Looking for Instructions for Under Bench RV AC Unit
- Q&A: Troubleshooting A Furrion Range/Oven Knob That's Always Lit Up Red
- Q&A: Replacement Switch and Wiring Diagram for Atwood G6A-8E
- Article: Converting Your RV Water Heater to Tankless
- Q&A: Recommended Replacement for Atwood G6A-7 Water Heater
- Q&A: Recommended Replacement for the Parallax 7455T
- Q&A: Best Replacement For Norcold N611 RV Refrigerator
- Article: What are the Common Types of Propane Fittings Used on RVs?