Does the Draw-Tite Class II Ball Mount # 3593 Use a 5/8 Inch Diameter Hitch Pin
Updated 03/09/2012 | Published 03/07/2012
Question:
Does this ball mount take a 5/8 dia pin hitch lock?
asked by: Jim G
0
Expert Reply:
Class I and II accessories like the Draw-Tite Class I Ball Mount you referenced all use a 1/2 inch hitch pin or lock. Class III, IV and V hitches use the thicker 5/8 inch diameter hitch pin or lock.
For your Class I accessory, I typically recommend a stainless locking hitch pin, like part # 40106.
expert reply by:
Mike L
0
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: How to Measure for Trailer Hitch Drop
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Recommended Parts Needed to Tow a Trailer With a 2003 Volvo S60
- Q&A: Can I Install a Hitch on a 2003 Ford Taurus?
- Q&A: Choosing the Correct Class I Ball Mount to Pull a Small Boat Trailer with a 2014 Kia Soul
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: How to Pick Out the Correct Ball Mount
- Q&A: Recommended Trailer Wiring for 2017 Honda Civic Hatchback
- Q&A: Does the Draw-Tite Hitch 24978 Require Trimming to Install on a 2024 Volkswagen Jetta GLI?
- Article: Trailer Hitch Installation Tips
- Article: My Trailer Hitch Doesn't Fit
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)