How to Install Plastic Fulton Fender on Trailer  

The Fulton Single Axle Trailer Fender with Top Step - White Plastic - 12" Wheels - Qty 1 #F008542 mounts using brackets like the Mounting Brackets for Trailer Fender - 8"/12" Wheels - Galvanized Steel - Qty 2 #CE26061G-2. I've…

I recommend using the Fulton Single Axle Trailer Fender #F008542 if you are wanting to mount the fender on the inner wheel flange. The Fulton Single Axle Trailer Fender #F008540 uses Mounting Brackets #CE26065PGA to hold the fender in place. It uses…

I do have an option for you but the closest sized fender we have for what you're looking for is the Fulton Single Axle Trailer Fender with Top Step part #F008542 which measures 23-11/16" long x 7-1/2" wide x 8-11/16" tall. This is…

The Fulton Single Axle Trailer Fender #F008559 referenced in your question is designed for use with 8 to 12 inch diameter wheels. If this is what you have, then the Fulton Fender should work as a replacement, however you may need to fabricate your…

If you currently have 8" wheels and want to eventually to upgrade to 12" wheels, I recommend CE Smith Trailer Fenders #CE17701G. I recommended these fenders because these can either be bolted-on or welded-on to make for a simpler install.…

We recommend having about 4" of clearance height-wise to account for suspension movement and at least 2" width-wise between your tire and trailer fender or trailer frame like part #HP66VR that was referenced. Since you are building a…

You would choose a side wind or top wind jack based on several factors. Each has its advantages. If clearance is an issue for the radius of a top wind, then you would choose a side wind. The opposite is also true. It is my experience that a side…

The Fulton Plastic Fender with Top Step, part #F008553, does not come with mounting hardware. Fulton does not provide mounting bracket kits for the fenders. You can use your fenders original mounting brackets or use the Redline Galvanized Steel,…

It sounds to me like you may have shorted out a wire somewhere along on the trailer's wiring harness. To test this, I recommend using a circuit tester like part #PTW2993. Have a friend sit in the vehicle and apply the brakes and turn signals…

You can mount the fenders directly to the trailer frame through the fender skirt on the back of the fender. I would recommend using large washers if you drill through the fender skirt and attach the fender directly to the trailer frame. If mounting…

The length of the hardware used to secure a fender using brackets such as #CE26061G-2 is going to depend on how thick the trailer frame is where the brackets and fender will be installed. You could bolt all the way through the frame which would mean…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…