How To Check Connection and Install Rear Sensor On Lippert Ground Control

Updated 08/12/2019 | Published 08/10/2019

Question:

Before replacing my lippert rear sensor is there anything i need to do before and after? 2011 cedar creek 6 point leveling system. External sensor error, cabling is good.

asked by: Brian

Helpful Expert Reply:

If the connection to the rear sensor is good then the sensor itself is bad. Typically the rear sensor error is due to a bad connection to the sensor and according to Lippert it is usually an obvious connection issue that you will be able to fix when you look at the rear sensor. If all the connections are okay and you still have the error then the sensor is bad. Page 7-8 in the installation instructions attached for the ground control explains how to install the rear sensor.

expert reply by: Heather A