Idler Hub Assembly with 6 on 5-1/2" Bolt Pattern for Timbren Axle-Less Trailer Suspension System

Question:

Hi. I’m upgrading my trailer to use as a camping rig. I’d like to get the 4” lift Timken axle-less suspension ASR3500S06 and these wheels and tires. Just wanna verify which hubs I need to get to fit the wheel and suspension. Thanks!

1

Helpful Expert Reply:

To fit the Contender ST225/75R15 Radial Tire w 15" Steel Mod Wheel # AC225R6DMM to the Timbren Axle-Less Trailer Suspension System - 4" Lift Spindle # ASR3500S06 you need the Trailer Idler Hub Assembly # AKIHUB-655-35-EZ-K. This comes with bearings, seals, EZ Lube grease cap, and lug nuts. Please note this is sold in a quantity of 1 so you need to order 2 for the Timbren kit you are installing.

I have attached some videos for you to check out as well.

helpful expert reply by:
1
Jon G

Question:

Thank you so much for your help. One last question: If I wanted to go with a lighter duty setup and use the Timbren ASR1THDS03 2200lb axles with the Contender AC15R45DMM wheels and tires, then which hubs would I need?

1

Helpful Expert Reply:

The 2.2K Timbren Axle-Less Trailer Suspension System # ASR1THDS03 actually uses the same spindle so you would still use the Trailer Idler Hub Assembly # AKIHUB-655-35-EZ-K for the Contender ST225/75R15 Radial Tire w 15" Steel Mod Wheel # AC225R6DMM.

helpful expert reply by:
1
Jon G

Products Referenced in This Question




Product Page this Question was Asked From


Follow up Questions

What do you think?

* e-mail address format: [email protected]

I would like an email notification if someone replies to my comment

Similar Expert Q&A Pages

See More Q&A Expert Answers >>