How Much Torque Is Applied to the Curt Class III Ball Mount with 2 Inch Ball
Updated 07/29/2019 | Published 07/26/2019 >
Question:
How much is the torque on the nut holding the ball mount?
asked by: Jan
0
Expert Reply:
The Curt Class III Ball Mount with 2" Ball part # C45056 comes pre-torqued to 250 ft. lbs.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Curt Class III Ball Mount with 2" Ball - 4" Drop - 2" Rise - 7,500 lbs
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- One Ball
- 2 Inch Ball
- Steel Shank
- Drop - 4 Inch
- Rise - 2 Inch
- Fits 2 Inch Hitch
- 7500 lbs GTW
- Pre-Torqued
- CURT
more information >
Continue Researching
- Article: How to Measure for Trailer Hitch Drop
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Bolt Hole Dimensions for etrailer Hitch that Fits 2020 Ford Transit T350
- Q&A: Recommended 2" Ball Mount to Clear the Spare Tire on a Jeep Wrangler
- Q&A: Is it Better to Go with Higher or Lower Rise Ball Mount than Needed
- Q&A: Can The Curt Ball Mount C45042 Be Used In The Rise Position?
- Q&A: How to Wire the Dexter Electric Over Hydraulic Trailer Brake Actuator
- Q&A: Recommended Custom Fit 5th Wheel Rails for a 2024 Chevy Silverado 2500
- Q&A: Replacement Recommendation for Dexter Axle 8-201 Hub Assembly on Older Horse Trailer
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Article: How to Choose the Right Trailer Hitch Class
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Curt Echo Full Review
- Article: How to Clean Weld Nuts for the Installation of a Trailer Hitch | etrailer.com

