Can the Trailer Valet XL Trailer Dolly Be Left Installed While In Tow
Updated 07/22/2019 | Published 07/18/2019
Products Featured in This Question
Question:
Can you leave the XL model attached to the frame with the mount bracket while towing like you can with the 5X model?
asked by: Jim
Expert Reply:
The Trailer Valet XL Trailer Dolly part # TVXL2 cannot be left installed on the trailer with the Trailer Valet XL Mounting Bracket part # TVXLMB while in tow. The dolly would need to be removed as the bracket is not made to hold this on the trailer while towing. If your tongue weight is under 500 lbs then you can use the Trailer Valet 5X Swivel Jack and Trailer Mover part # STC-V211 but otherwise you would just need to remove the Trailer Valet XL Trailer Dolly each time and store it in the vehicle or trailer.
Product Page this Question was Asked From
Trailer Valet XL Trailer Dolly with Chain Drive - 2" Hitch Ball - 10,000 lbs
- Trailer Dolly
- Manual Dolly
- 10000 lbs
- 19 Inch Tall
- 20 Inch Tall
- 2 Inch Ball
- Trailer Valet
more information >
Continue Researching
- Q&A: Recommended Tow Dolly for a 8,800 lbs Travel Trailer
- Q&A: Recommended Trailer Valet Trailer Dolly for Moving Loaded Trailer Up and Down Driveway Steep Grade
- Q&A: Trailer Valet XL Hitch Ball Rotating During Use
- Q&A: Is There a Trailer Dolly Which Connects Between the Truck & Trailer To Keep Tongue Weight off Truck?
- Q&A: Dolly Recommendation for Moving Trailer That Attaches to Coupler
- Q&A: Looking for Replacement Ball Assembly and Hand Crank for Trailer Valet XL Dolly
- Q&A: Availability of Powered Dolly that Could Move 12,000 lb Trailer Up 10 Degree Driveway
- Article: How to Measure for Trailer Hitch Drop
- Article: Trailer Wiring Diagrams
- Article: The 4 Crucial Choices You'll Make When Buying a Boat Trailer
- Article: How to Launch a Boat from a Trailer (And Load it Back Up)
- Article: Installing an Electric Brake Controller on a 2013 Dodge Ram
- Article: How to Install E-Track in 3 Easy Steps
- Article: Trailer Maintenance Schedule