Replacement Trailer Connector That Will Fit In Bumper On a 2006 Dodge Ram 2500
Updated 07/17/2019 | Published 07/16/2019
Question:
There arent any dimensions listed, and it states the bracket has to be used. I have a 2006 Ram 2500 with factory bumper and a 7 way already installed. Will this fit the factory hole that the current 7 way is in?
asked by: Greg
0
Expert Reply:
Yes, the 7-Way & 4-Way Replacement Connector part # 42145 will fit the factory cutout in the rear bumper on your 2006 Dodge Ram 2500 which you can see in the attached photo. Therefore, the included mounting bracket is not needed.
expert reply by:
Conner L
0
click to enlarge
Product Page this Question was Asked From
7-Way & 4-Way Replacement Connector for Dodge OEM Style Plugs
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- No Converter
- No Tow Package
- 4 Flat
- 7 Blade
- Plug and Lead
- Plug-In
- Hopkins
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Is Furrion Vision S+ Direct Replacement for Vision S
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Recommended Plug and Play Flat Tow Wiring Harness for a 2024 Jeep Wrangler Sport
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Q&A: Replacement Hydraulic Brake Actuator For Tie Down Engineering LP8000
- Q&A: What is the Difference Between 7-Way RV and Utility Trailer Connectors
- Q&A: 7-Way Trailer Wiring Harness Replacement For A 1995 Ford F-150
- Q&A: Replacement Manual Override Plug For A 3,500lb RAM Electric Trailer Jack
- Q&A: Replacing 6-Way on Trailer With 7-Way Connector
- Article: Electric Brake Controller Installation on Dodge Ram Trucks to 2012
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Measure for Trailer Hitch Drop
- Article: Trailer Wiring Diagrams