Troubleshooting Trailer Turn Signals on 2015 Nissan NV 2500 Not Working

Updated 07/16/2019 | Published 07/15/2019

Question:

2015 nissan nv2500. Have a wiring harness that was working since new. I have running lights on trailer and electric brakes but no turn signals. I have checked all of the fuses and they seem to be ok. Help

asked by: Mike S

Expert Reply:

First thing you should do at this point is test the 7-way of the wiring harness with a circuit tester part # PTW2993 for voltage on all of the right pins when the taillight signals are being applied. Just like in the video I attached.

If the voltage checks out there but the trailer lights still don't function right then the problem is on the trailer wiring. That would mean that problem is either due to a ground issue or a short issue.

Make sure that the trailer side connector are clean and free of corrosion inside and out. The main connector grounds should be attached to clean and corrosion free bare metal surfaces. The light grounds should also be attached to clean and corrosion free bare metal surfaces. If there is anything between a light ground and the metal trailer frame or if the trailer has an aluminum frame, tilt bed, or folding tongue, any of these things can interrupt the ground. Running jumper wires from the light grounds to the main trailer connector ground can help.

If the problem is on the vehicle side then I would first recommend you double check how the harness is installed on your vehicle, make sure all of the connections are good and tight. You should check all towing related fuses and relays as well.

expert reply by: Jameson C