Buzzing Sound Coming From the Jensen RV Stereo Part JWM60A

Updated 06/22/2020 | Published 07/02/2019

Question:

I switched the AWM910 with the JVM60A and the unit is making a clicking, buzzing sound...?

asked by: D W

Expert Reply:

I spoke to my contact at Jensen about the Jensen RV Stereo part # JWM60A and they informed me that they would first recommend that you perform a reset by sticking a ball point pin inside the unmarked reset hole on the bottom right hand side of the unit. If this does not fix the clicking/buzzing sound then you will need to check your wiring connections at the back of the unit. If all else fails you can either replace the unit or take your trailer to an RV service center for troubleshooting.

expert reply by: Conner L

Clarence J.

6/14/2020

Mine does the same thing, starts buzzing when power is connected and causes lights to brighten in the trailer. Also noticed the system resets when adjusting balance. Disconnected speakers, still does the same thing. Did not find any unmarked hole with a reset button.

Chris R.

6/18/2020

Do you have the Jensen # JWM60A or is it a different model? If it's this model you can actually press in on the "enter" knob button to reset the unit. If this doesn't help then there's likely an internal issue and it will need to be replaced.

Clarence J.

6/18/2020

@ChrisR resolved the issue a few days back, was on the charging circuit. The load of the radio caused voltage to go up to 17 volts causing the buzzing and other issues. Changed circuit, problem solved.