How to Install Pop & Lock Wiring to B Pillar on 2019 Honda Ridgeline for Easier Install
Updated 07/03/2019 | Published 07/01/2019
Question:
Can you please show the alternate way step 4 on a video how to install it? This is for the Honda Ridgeline 2019 pop and lock power lock
asked by: Patrich
Expert Reply:
The photos that you referenced for installing the Pop & Lock Custom Tailgate Lock # PAL8600 on your 2019 Honda Ridgeline actually came from Pop & Lock.
Currently (July 2019) we don't have an installation video showing this method but basically you just need to route the wiring to the B pillar (by the driver's side seatbelt) to connect the wiring. You will use the same small red and small yellow wires as in the installation instructions like you see in the photos. You can follow the attached installation video on a '19 Ridgeline and then just route the wiring to that B pillar instead of the engine compartment like we do in the video.
Product Page this Question was Asked From
Pop & Lock Custom Tailgate Lock - Power - Black
- Tailgate Locks
- Lock Only
- Power Lock
- Keyed Unique
- Vehicle Specific
- Black
- Pop and Lock
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: How to Wire Pop & Lock Tailgate on Honda Ridgeline Using Wiring Behind B-Pillar
- Q&A: Does The BAKBox 2 and BAKFlip Cover Allow Access To Trunk In Honda Ridgeline
- Q&A: Will the BAKFlip G2 Hard Tonneau Cover # BAK26601 Limit Trunk Access on a 2014 Honda Ridgeline
- Q&A: Installing The BakFlip F1 Hard Tonneau Cover On 2012 Honda Ridgeline
- Q&A: Availability of Replacement Key for Pop & Lock Custom Tailgate Lock
- Q&A: Trailer Hitch Confirmed to Fit a 2022 Ford Bronco Sport
- Q&A: Are All RV Hitches for a 2004 Fleetwood Tioga Rated for 3,500 lbs?