Will the Universal-Design Rocker Switch With Dual Actuators Install In a Standard Switch Cutout
Updated 06/10/2019 | Published 06/08/2019
Products Featured in This Question
Question:
Is this a double switch, that is the same size as 1 standard acc. Switch
asked by: Jason H
Expert Reply:
The Universal-Design Rocker Switch part # PK34312 is a dual actuated switch that gets installed in a 0.830" wide x 1.450" tall cutout which is a very common size. Therefore, yes the above will install inside a standard 12 volt rocker switch cutout. For reference, the Universal-Design Rocker Switch part # PK34360 is a single actuated switch that gets installed in the same 0.830" wide x 1.450" tall cutout as the above.
The Female Spade Terminal Quick-Disconnect part # DW01899-1 is what you would want to use to attach to the back of the switch.
Product Page this Question was Asked From
Universal-Design Rocker Switch - Dual Actuators - DPDT - High-Off-Low - 12 Volt - 20 Amp
- Accessories and Parts
- Wiring
- Switches
- Rocker Switches
- 20 Amp
- Pollak
more information >
Continue Researching
- Article: Electric Trailer Brakes: How They Work & What to Buy
- Q&A: Parts Needed To Install Brake Controller in 2015 Audi Q5 with 7-Way
- Q&A: Replacing 6-Way on Trailer With 7-Way Connector
- Q&A: Solution for Von Weise Fifth Wheel Landing Gear with Bad Motor
- Q&A: Replacement RV Microwave for High Pointe EM925ACW in LQ Horse Trailer
- Q&A: Replacement Circuit Board for Atwood GC66A10E Water Heater
- Q&A: Replacement Screw-On Vent Lid and Lift Arm for Fan-Tastic Roof Vent
- Q&A: RV Cover Recommendation Retro Style 189R by Riverside
- Article: Trailer Wiring Diagrams
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers