Parts Needed To Install Brake Controller in 2015 Audi Q5 with 7-Way

Published 02/09/2017

Products Featured in This Question

10 Gauge Wire - Blue Primary - Per Foot

(109)

$1.61

Wiring Kit for 2, 4, 6, and 8 Brake Electric Trailer Brake Controllers

(168)

$57.95

Question:

I have a 2015 Audi Q5 diesel with the factory hitch installed. I need a brake controller. My vehicle already has the 7 way connector. Which controller and adapter if needed do I need?

asked by: Jason W

Expert Reply:

For a brake controller I would recommend the Prodigy P2 Brake Controller part # 90885. This is our best selling brake controller because of how well it works and how easy it is to setup. This is a proportional brake controller that senses the amount of braking the tow vehicle is applying and applies a proportionate amount to the trailer brakes.

Next, for a wiring kit to install the brake controller and the 7-way adapter you would want the Wiring Kit for 2 and 4 Brake Electric Brake Controllers # 5506. This will provide the power source and ground for the wiring for the brake controller. You will need to test the wires from the brake pedal switch of your vehicle to find a circuit that has voltage when the brakes are applied and none when not applied. This will be the circuit you will run the red wire to.

Finally you will need to run a length of 10 gauge wire (part # 10-1-1) from the brake output circuit of the controller to the brake output circuit of the 7-way (blue wire). The # 10-1-1 is sold by the foot so you will need to order a quantity of the amount of feet you will need.

I attached an FAQ on installing brake controllers for you to check out.

expert reply by: Jameson C