How to Remove Hose Line from Fitting for Air Lift Load Controller Compressor System

Updated 06/05/2019 | Published 06/04/2019

Products Featured in This Question

Air Lift Load Controller Compressor System for Air Helper Springs- Heavy Duty - Dual Path

(170)

$456.10

Air Lift Air Hose Cutter

(99)

$30.45

Air Lift Union Tee for 1/4" Air Lines

(997)

$6.94

Question:

how to realese hose from fitting I need to release and recut a hose for the A25856 whats the best way

asked by: Jeffry S

Helpful Expert Reply:

To release an air line from one of the T-Pieces # AL21838 that came with your Air Lift Load Controller Compressor System # AL25856 you just need to put even pressure on the circular piece that the hose slides into. If you check out the attached video you can see our install team doing this at the 1:36 minute mark with a boxed wrench. To make sure you make a clean cut on your hose be sure to use a hose cutter like part # AL10530.

I have attached a photo showing which direction you need to move the circular piece to remove the hose. You only need to move one of the pieces for whichever hose you are trying to remove, you do not need to move all 3 pieces for this.

expert reply by: Jon G