Diameter of the Replacement Tube Cap for Bulldog Round Trailer Jacks with a Sidewind Handle
Updated 02/01/2012 | Published 01/28/2012
Question:
What is the OD of this jack cap?
asked by: Darrell E
0
Expert Reply:
I went out to the warehouse and pulled a Replacement Tube Cap, # BD015500, to measure it. The Outer diameter at the widest point is 2-1/4 inches. The outer diameter at the part that fits into the jack is a little less than 2-1/8 inches (2.10 inches). I included a picture that shows these dimensions.
expert reply by:
Michael H
0
click to enlarge
Product Page this Question was Asked From
Replacement Tube Cap for Bulldog Round Jacks with a Sidewind Handle
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Caps
- Tube Cap
- Bulldog
more information >
Continue Researching
- Search Results: replacement master cylinder cap
- Search Results: bulldog trailer jack
- Video: Bulldog Bolt-Thru Swivel Trailer Jack Review
- Shop: Bulldog Bolt-Thru Swivel Trailer Jack - Bolt On - Sidewind - 10" Lift - 1,500 lbs - Gray
- Q&A: Do 3,500 lb Trailer Axles and 5,200 lb Axles Use Same Hub/Drums and Brake Assemblies
- Q&A: What are the Dimensions of a #99 Spindle
- Q&A: How to Wire the Dexter Electric Over Hydraulic Trailer Brake Actuator
- Q&A: Replacement Trailer Taillight Lens Marked DOT P2PCA 99
- Q&A: Correct Replacement for TDE 46210 Trailer Hub
- Q&A: What is a #84 Spindle and How Do I Know I Have One On My Trailer?
- Q&A: Difference Between L44649 and L44949 Trailer Hub Bearings
- Article: How to Measure Your Trailer Wheel Bolt Pattern