Replacement for Grease Seal with 2.335 Outside Diameter and 1.5 Inside Diameter
Updated 04/12/2019 | Published 04/11/2019
Question:
I need a seal with 2.335 outside diameter, and my axle where the seal runs is 1.5 diameter .
asked by: Ben
Helpful Expert Reply:
The closest option we have to your measurements is the Grease Seal # SL150 that features an outside diameter of 2.332 inches and an inside diameter of 1.500 inches. This is awfully close to the numbers you provided so you may want to measure your existing seal once more to see if it matches. Also keep in mind that grease seals tend to get a bit distorted from the physical act of removing them from the hub so this is likely the correct seal.
If you can find a number stamped inside the seal itself this might also be helpful in verifying if this is the correct fit. I have attached a short video review that you can check out as well.
Product Page this Question was Asked From
- Trailer Bearings Races Seals Caps
- Seals
- Grease Seals - Single Lip
- 1.50 Inch I.D.
- 2.33 Inch O.D.
- Redline
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Double Lip Grease Seal - ID 1.249" / OD 1.983" - Qty 1
- Shop: Timken Grease and Oil Seal - Double Lip - I.D. 1.719" / O.D. 2.565" - 473336
- Q&A: Recommended Tire Linc Pro TPMS for RVs and Trailers
- Q&A: Can I Get Replacement Brackets And Pins For MaxxAir 2 Vent Cover?
- Q&A: How Does Coleman-Mach Underbunk RV AC Vent Heat
- Q&A: Does Coleman-Mach Underbunk RV AC Come With Tubes
- Q&A: Replacement Grease Seal For a Trailer Hub Using LM11949 Outer Bearing and LM67048 Inner Bearing
- Q&A: Replacement High Torque Winnebago/Itasca Slide-Out Motor PN 181862-01-700
- Q&A: How to Power a Furrion Camera System w/ a 2024 Chevrolet Silverado 3500
- Article: Most Popular Wheel Bearings
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Trailer Wiring Diagrams