Bolt Recommendation for Fulton Fas-Lock Coupler Installation
Published 12/30/2011
Question:
Which mounting bolts should I use for this coupler?
asked by: Shin
0
Expert Reply:
You would want to use 2, 1/2 inch diameter bolts that are 4 inches in length. I pulled a Fulton Fas-Lok Coupler # F343000301 and checked the installation instructions to confirm the bolt recommendations.
expert reply by:
Jameson C
0
Continue Researching
- Shop: Spare Tire Cover
- Search Results: chains
- Shop: CE Smith Safety Chains with S-Hooks - 24" Long - 3500 lbs
- Shop: Adco Spare Tire Cover for 24" Diameter Tires - Diamond Plate - Qty 1
- Shop: Easy Grease Trailer Idler Hub Assembly for 3.5K Axles - 5 on 4-1/2 - Pre-Greased
- Article: Most Popular Wheel Bearings
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Video: In-Depth Review of the Easy Grease Trailer Idler Hub Assembly for 3.5K Axles
- Video: Review of TruRyde Trailer Bearings Races Seals Caps - Caps - DC250L-DCRP
- Q&A: Bolt Size Recommended For Channel Style Tongue Trailer Coupler Installation
- Q&A: Replacement Rear Taillights and Clearance Light Bar for Boat Trailer
- Q&A: Upgrading Lights on 2000 Tracker PT175 Trailer to LED
- Shop: CE Smith Trailer Idler Hub Assembly w/ Case for 3.5K Axles - 5 on 4-1/2 - Galvanized - Pre-Greased
- Search Results: spare tire cover
- Search Results: trailer safety chains
- Search Results: jacketed wire
- Search Results: 4 pin wiring harness
- Shop: Offset Trailer Spare Tire Mount by Dutton-Lainson
- Shop: Karrier ST175/80R13 Radial Trailer Tire with 13" Aluminum Wheel - 5 on 4-1/2 - Load Range C
- Shop: Optronics LED Combination Trailer Tail Lights - Submersible - 40 Diodes - Driver and Passenger Side
- Search Results: trailer fenders
- Search Results: truck bed protection