Does Rubber Trailer Bumper Require Steel Mounting Strip to Install
Updated 04/05/2019 | Published 04/04/2019
Question:
Doesnt this bumper require a steel mounting strip on the inside? I have installed one before and it did but I cant seem to find the part number that would be compatible with this bumper.
asked by: Eric E
0
Expert Reply:
The Pre-Drilled Round Rubber Trailer Bumper # D3-96 does not require a steel mounting strip in the inside to install.
This bumper has pre-drilled holes and all you need to do is use 9/16" bolts to bolt it onto the rear of your trailer and you are good to go.
expert reply by:
Kyle S
0
Product Page this Question was Asked From
Pre-Drilled Round Rubber Trailer Bumper - 96" Long x 3" Wide
- Trailer Door Parts
- Ramp Door Bumpers
- Bumper Strip
- Bolt-On
- 3 Inch Wide
- 96 Inch Long
- Rubber
- Redline
more information >
Continue Researching
- Q&A: What hardware is used to attach the 96inch predrilled rubber bumpers?
- Q&A: How Wide is the Curt Weight Distribution Shank C17132?
- Q&A: Replacement for 84 Inch Bumper on Horse Trailer
- Q&A: How to Determine Trailer Hub's 5 Lug Bolt Pattern
- Q&A: Plate For Trailer Ramp Edge And Gap Between Floor And Ramp To Allow Wheels To Roll Without Catching
- Q&A: Replacement Drop Down Window Latch for a 2001 Featherlite Horse Trailer
- Q&A: Weight of Redline Pre-Drilled Round Rubber Trailer Bumper # D3-96
- Article: Slipper Spring Trailer Suspension System Review
- Article: Trailer Wiring Diagrams
- Article: Trailer Maintenance Schedule
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: How to Measure for Trailer Hitch Drop