Remove Face Plate of Jensen RV Stereo part # JWM60A to Access Install Hardware
Published 04/03/2019
Question:
I just purchase this Jenson model JWM60A. I need instructions to remove the face plate, to gain access to the holes for mounting the device.
asked by: Greg H
0
Expert Reply:
If you check out the picture I attached you'll see a recessed section on the side of the Jensen Stereo part # JWM60A. Using a small slot screwdriver you'll need to pry gently on that so that the panel removes giving you access to the mounting screw/hardware for this stereo.
expert reply by:
Jameson C
0
click to enlarge
Continue Researching
- Q&A: How to Remove Face Plate on the Jensen RV Stereo # JWM70A
- Shop: Jensen Mechless RV Stereo - Double DIN - Bluetooth, USB - 36W - 3 Zones - 12V
- Shop: Jensen Mechless RV Stereo - Single Din - Bluetooth - 2 Zone - 12V
- Q&A: How to Remove Trim Pieces From Jensen RV Stereo # JWM60A
- Shop: Jensen Indoor RV Speaker - Recessed Mount - 6" Diameter - 24 Watts - White - Qty 1
- Q&A: Recommended Replacement Stereo for Jensen AWM970
- Q&A: Best Replacement for Linear Series RV5090 RV Stereo
- Q&A: Best Replacement for a Jensen RV Stereo AWM910
- Q&A: Recommended Replacement For A Magnadyne RV5090 RV Stereo System
- Q&A: Recommended Replacement for Old Jensen JWM6A RV Stereo
- Article: Holiday 2025 | Staff Picks for Real-Life Adventures
- Article: How to Raise Your Travel Trailer Height
- Article: How Much Solar Power Do I Need For My RV?
- Article: Which RV Propane Tank Size Do I Need?
- Article: Trailer Lighting Requirements
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Best Bike Racks for Electric Bikes