Can Wheel Studs on Trailer Axle Be Replaced
Updated 04/03/2019 | Published 04/02/2019
Products Featured in This Question
Question:
Can you replace a wheel stud on a triler if the splines got worn out and the bolt started spinning?
asked by: Carlos A
0
Expert Reply:
Yes, the studs on trailer hubs are replaceable. You'd need to know the diameter of the stud you'd be replacing as well as the length. I attached a link to a page that has all of the studs we offer. The most popular stud replacement we offer is the part # K12WB2 which is 2 inches long and 1/2 inch in diameter.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Trailer Hub Wheel Stud, Drive-In, 9/16" x 2-1/2" - Qty 1
- Accessories and Parts
- Boat Trailer Wheels
- Trailer Hubs and Drums
- Trailer Tires and Wheels
- Wheel Studs
- 9/16 Inch Diameter
- Drive-In Stud
- 2-1/2 Inch Long
- Redline
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Are Bearings Already Installed On TruRyde Trailer Hub and Drum Assembly
- Q&A: What Brake Pads Does Kodiak Disc Brake Kit # K2R35S Come With
- Q&A: Stainless Steel Disc Brake Setup for Tie Down Engineering 3500 lb Axle
- Q&A: Stainless Steel Disc Brake Kit Compatible with Magic Tilt Trailer
- Q&A: Replacement Brake Pad and Rotor for Kodiak Stainless Steel 10" Disc Brake Kit
- Q&A: Replacement Studs for RVD-H-865 7k Hub/Drum
- Q&A: Replacement Oil Bath Hub Drum for 8 on 6-1/2 Bolt Pattern on 8,000 lb Axle
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Printable Trailer Bolt Hole Pattern Template
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: Best Bike Racks for Electric Bikes