No Drill Trailer Hitch Recommendation for 1985 Chevy Blazer K5
Updated 03/29/2019 | Published 03/28/2019
Question:
I have a 1985 Chevy k5 blazer. I want to buy a receiver hitch hitch for it. Which hitch do I need? Also do I need to drill hole in my frame to make it work? How many bolts hold the hitch in? Thanks
asked by: Jason R
0
Expert Reply:
For your 1985 Chevy Blazer K5 the Curt hitch part # C13401 that you referenced is a confirmed fit. It does not require any drilling to install and is held in place with 4 Grade 5 carriage bolts that are 1/2-13 x 1 3/4.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 500 lbs TW
- 5000 lbs GTW
- 10000 lbs WD GTW
- 2 Inch Hitch
- 1000 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: Trailer Hitch
- Q&A: Dimensions of the Curt Trailer Hitch Receiver Part # C13401
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Bolt Holes Dimensions for the Curt Trailer Hitch Receiver # C13401
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Comparing Curt Trailer Hitches for a 2014 GMC Sierra 1500
- Q&A: Will C55312 T-Connector Vehicle Wiring Harness Fit 1984 GMC S15 Pickup
- Q&A: Trailer Hitch and Wiring for a 1977 Chevy Blazer 2-Wheel Drive
- Article: Trailer Wiring Diagrams
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: Is a 2001 Ford Explorer Sport Trac Pre-Wired for a Brake Controller