Installation of Replacement Joint Assembly Hardware Kit for Lippert Electric Coach Step
Updated 03/18/2019 | Published 03/16/2019
Question:
Just received the Replacement Joint Assembly Hardware Kit for my Kwikee steps. What is the proper order for installing the step bolt? Does the bolt go through from the outside, then slide the bushing on from the inside, with the small end facing the step, then the washer, then the locking nut? Or does the washer go on the outside next to the bolt head? Thanks.
asked by: Graham R
Expert Reply:
I reached out to to the manufacturer, Lippert, who told me that to install the Replacement Joint Assembly Hardware Kit for Lippert Electric Coach Step # LC216567 who told me the bushing will go in the hole, and then you put the bolt through; the washer will go on after than, and then the nut.
Product Page this Question was Asked From
Replacement Joint Assembly Hardware Kit for Lippert Electric Coach Step
- Accessories and Parts
- RV Steps
- Hardware
- Lippert
more information >
Continue Researching
- Q&A: Demco Air Force One Braking System For Factory Prepped Tiffin RV
- Q&A: Replacement Parts for Lippert Electric Coach Steps 26 lci 165046
- Q&A: Replacement RV Step Motor for Part Number 300-1406
- Q&A: How Long Does It Take To Install Air Force One Supplemental Braking System
- Q&A: Replacement Bolt Needed for Lippert Gear # LC301696
- Q&A: Parts Needed to Flat Tow a 2013 Kia Soul Manual Transmission
- Q&A: What Is Needed To Flat-Tow 2011 Kia Soul With manual Transmission Behind Motorhome
- Article: Stability Control for Heavy Duty Vehicles
- Article: How to Measure for Motorhome Steps