Can the 10K Pro Series Square Jack be Used in a Dual Setup
Updated 02/18/2019 | Published 02/15/2019
Products Featured in This Question
Question:
I’m assuming this jack can be used in tandem when 2 jacks are purchased? Thanks
asked by: Aaron
0
Expert Reply:
Yes, you can use the Pro Series Square Jack # PS1400950376 in a dual setup as long as it is with the same model Pro Series jack like part # PS1400960376.
Just be sure these are installed at the same height and your connecting rod is long enough for your application.
expert reply by:
Jon G
0
Product Page this Question was Asked From
Pro Series Square Jack - Front Pin Drop Leg - Spring Return - 10K Lift - 26" Travel
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- 5th Wheel Trailer
- Gooseneck Trailer
- Side-Mount Jacks
- Standard Grade
- 9001 - 10000 lbs
- Manual Jack
- 26 Inch Lift
- Weld-On
- With Rectangle Foot
- Pro Series
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Recommended Replacement for Dometic Over the Range Microwave DOTR12CB
- Q&A: How To Determine If Boat Trailer has 10 Inch or 12 Inch Brake Assemblies
- Q&A: Replacement Fender for Yacht Club Jet Ski Trailer Measuring 20.5 Inches Between Mounting Holes
- Q&A: How to Loosen Self-Adjusting Brakes
- Q&A: Do Self-Adjusting Trailer Brake Assemblies have to be Initially Adjusted
- Article: Trailer Wiring Diagrams
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Q&A: Will the Camco Propane Tank Cover Part # CAM40565 Fit Over a 20Lb Tank with Regulator and Bracket
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Q&A: How Can I Mount a 20 LB Propane Tank to a Trailer Hitch on my Camper Van
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Jacks