Distance From Top Adjustment Hole to King Pin Surface of Ram Gooseneck 5th Wheel Adapter KPG5-Q30IP

Question

Question:

Hi i need to know how many inches from the plate to the high hole cz i a ready have a kingpin adapter but i need go high but i can’t cz no more holes And my guy don’t recommend me open another hole so i just need buy a go high adapter thanks

asked by: Gio

0

Expert Reply:

From the center of the top adjustment hole on the Ram Gooseneck to 5th Wheel Trailer Coupler Adapter part # KPG5-Q30IP measures 15 inches.

expert reply by: Jameson C

0

click to enlarge

Answer 1

The total length of the #KPG5-Q30IP is 29" from the bottom of the kingpin to the top of the tube. This adapter is 15" from the plate to the top of the highest pin hole.

view full answer...

Answer 2

The towing capacity of the, #KPG5-Q30IP, Gooseneck to Fifth Wheel Trailer Adapter - Square is 30,000 pounds. This item is produced for converting a king pin for attaching to a fifth-wheel hitch.

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 7

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 8

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 9

Hey Ron, congratulations on the new trailer! I have a Jay Feather myself and love it. You're definitely off to a great start with a weight distribution hitch, it will make a world of difference towing that trailer with your F-150. The Weigh Safe…

view full answer...

Distance From Top Adjustment Hole to King Pin Surface of Ram Gooseneck 5th Wheel Adapter KPG5-Q30IP

Product Page this Question was Asked From

Continue Researching