Why Is There a Flame Flare Up While Starting the Camco Olympian Wave 3 Catalytic Safety Heater
Updated 01/24/2019 | Published 01/23/2019
Question:
I purchased one of these Wave 3 heaters and lately during the start-up process where you hold in the button for one minute I typically get what can only be described as a flame flare up sometime during that one minute process. And that can be rather unnerving. I would like to know what causes this and how I can correct it.
asked by: Ken
Expert Reply:
The flame flare up that you described on the Camco Olympian Wave 3 Catalytic Safety Heater part # CAM57331 is caused by the flame spreader. The flame spreader then warms the thermocouple. Once the thermocouple is warm it will send gas to the pad which ignites and expels heat. There is no way to correct it as that is how the unit is designed to operate.
Product Page this Question was Asked From
Camco Olympian Wave 3 Catalytic Safety Heater for Small RVs
- RV Heaters
- Propane Heater
- Interior Heating
- Camper Van
- Teardrop Camper
- Truck Bed Camper
- Camco
more information >
Continue Researching
- Q&A: Troubleshooting Camco Olympian Wave 3 Catalytic Safety Heater That Does Not Stay Lit
- Q&A: Replacement Toilet Base Seal for a Dometic 510 RV Toilet
- Q&A: What Hitch Extension Is Best For 2021 Chevy Silverado LT With Lance Truck Camper?
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Q&A: Gooseneck Hitch for FL70 Freightliner
- Q&A: Recommended Frame Mounted Camper Tie-Downs For A 2024 Chevy Silverado 3500
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Recommended Disc Brakes for a Boat Trailer
- Q&A: Can Holding Tank Heater be Installed Between Metal Straps
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Best RV Roof Vents
- Article: How (and Where) to Connect an RV Propane Grill
- Article: 2 Steps for Hooking Up an External Propane Tank to Your RV