Installing Pop & Lock # PAL8600 on 2018 Honda Ridgeline
Updated 01/07/2019 | Published 01/04/2019
Question:
In a response to a question, Jason S. referred to an alternate hookup location on the drivers side B pillar. How is the wiring routed into this space?
asked by: Jim D
Expert Reply:
When installing the Pop & Lock Custom Tailgate Lock # PAL8600 on your 2018 Honda Ridgeline you will drop the wiring behind and down from the tailgate. You can then route the wire to the front of the vehicle under the driver's side of the truck, being sure to avoid any moving parts or heat sources. The best way to route the wiring inside the driver's side cab will still be to snake it through the engine compartment and through the rubber grommet in the firewall that the factory wire harness runs through from the fuse box.
I have attached the complete installation instructions that you can check out along with a video that you can use for reference (although in the video our installer connects to the fuse box behind the kick panel instead of the B pillar).
Product Page this Question was Asked From
Pop & Lock Custom Tailgate Lock - Power - Black
- Tailgate Locks
- Lock Only
- Power Lock
- Keyed Unique
- Vehicle Specific
- Black
- Pop and Lock
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: How to Wire Pop & Lock Tailgate on Honda Ridgeline Using Wiring Behind B-Pillar
- Q&A: Installing The BakFlip F1 Hard Tonneau Cover On 2012 Honda Ridgeline
- Q&A: Will the BAKFlip G2 Hard Tonneau Cover # BAK26601 Limit Trunk Access on a 2014 Honda Ridgeline
- Q&A: Does The BAKBox 2 and BAKFlip Cover Allow Access To Trunk In Honda Ridgeline
- Q&A: Availability of Replacement Key for Pop & Lock Custom Tailgate Lock
- Q&A: Trailer Hitch Confirmed to Fit a 2022 Ford Bronco Sport
- Q&A: Are All RV Hitches for a 2004 Fleetwood Tioga Rated for 3,500 lbs?