How Thick is the Camco Grip Tape 25401
Updated 01/02/2019 | Published 12/31/2018
Question:
How thick are these, I have landscape trailer with mesh tailgate ,can you drill holes in this rubber and put small bolts and washers through them and the mesh to hold. Motorcycle slides when backing down ramp while holding front brake. I ordered from your company before.
asked by: Tim
Helpful Expert Reply:
The Camco Grip Tape part # CAM25401 is around .03" thick. I called the manufacturer and they did not see any issues drilling holes into the grip tape for nuts/bolts. If you need a reference to .03" thick it is about that of most duct tapes.
Product Page this Question was Asked From
Camco Grip Tape - 15' Long x 2" Wide - Black
- Accessories and Parts
- RV Steps
- Grip Tape
- 2 Inch Wide
- 15 Feet Long
- Camco
more information >
Continue Researching
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Trailer Wiring Diagrams
- Article: My Trailer Hitch Doesn't Fit
- Q&A: How Can I Get Additional Trailer Wiring Signals at the Rear of my Durango
- Q&A: Replacement Propane Gas Detector for an Atwood 31013 Propane Detector
- Q&A: Step Rug And Grip Tape For Lippert Quad Step SolidStep
- Q&A: Trailer Running Lights Do Not Work but Brake Lights and Turn Signals Do Work
- Q&A: Troubleshooting Right Side Trailer Lights That Are Dim
- Q&A: Recommended Trailer Battery Charging System for Enclosed Motorcycle Trailer for Tools and Mattress
- Q&A: Battery Tender/Trickle-Charger Setup for a 6x12 Neo Trailer