Will Auxiliary Lights on Tow Vehicle Automatically Light Up When Connected to Reverse Circuit
Published 12/18/2018 >
Question:
if I connect a pair of bumper mount auxiliary back up lights and power them by splicing it into the wiring harness of my 7 pin plug on the vehicle, using the yellow center wire, will the lights come on automatically when in reverse, or is there a relay that needs installed in my fuse panel?
asked by: Steve O
Helpful Expert Reply:
As long at the center pin of the 7-Way connector on your tow vehicle receives power when you put the vehicle in reverse then auxiliary backup lights will light up automatically when you put the vehicle in reverse.
I do recommend installing diodes like part # RM-690 just to ensure that any issues that may arise with the auxiliary lights doesn't backfeed into your vehicle wiring.
Product Page this Question was Asked From
Roadmaster Single Park Light Diode
- Accessories and Parts
- Flat Tow Wiring Harness
- Diodes
- Roadmaster
more information >
Continue Researching
- Q&A: Diode Recommendation to Prevent Trailer Battery From Backfeeding onto Vehicle Wiring
- Q&A: Recommended Diode for Charging Line From Motorhome to Towed Vehicle (Toad)
- Q&A: How to Install Roadmaster 690 Diode to Fix 12V Power Issue on 2024 GMC Sierra Denali
- Article: Trailer Wiring Diagrams
- Q&A: What Do I Need to Flat Tow a 2026 Jeep Grand Cherokee L Summit?
- Q&A: How to Prevent Battery Backfeeding and Breakaway Battery Charging Off Trailer Battery
- Q&A: Parts Needed To Flat Tow A 2026 Jeep Grand Cherokee L
- Q&A: How to Prevent Backfeeding On Charge Line Kit
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: VCC Pickup and Dropoff
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs

