How Does the Ultra-Fab Frame-Mount Stabilizer Jack Install on a Trailer
Published 11/15/2011
Question:
How is this jack assembly attached to the trailer?
asked by: Ed S
0
Expert Reply:
Ultra-Fab Stabilizer Jack # UF39-941707 will bolt onto a trailer using the bolt holes that are present on the mounting flanges of this jack as well as with the included nuts and bolts. You will most likely have to drill holes in the frame of your trailer so that you can install this jack.
Check out the picture I attached that shows the mounting flange up close.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
Ultra-Fab Power Twin II Electric Stabilizer for Trailers and RVs - 22" Lift - 6,000 lbs
- Camper Jacks
- 5th Wheel Camper
- Travel Trailer
- Stabilizer Jacks
- Steel
- 5001 - 6000 lbs
- Electric Jack
- 22 Inch Lift
- Bolt-On
- 1 Jack
- Ultra-Fab Products
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Can The Ultra-Fab Electric Stabilizer Be Added To A Trailer With A Lippert Stabilizer
- Q&A: Scissor jacks vs Ultra-Fab Power Twin II Electric Stabilizer
- Q&A: Does Lippert High-Speed Power Stabilizer Jack Have a Weight Capacity
- Q&A: Dimensions of Motor and Gear Box of Ultra-Fab Power Twin II Electric Stabilizer # UF39-941707
- Q&A: Replacement Landing Gear Motor, Gear Box and Switch for Model 1A065012-02-01
- Q&A: Can I Install a 4-Point Control Module to a 6-Point Lippert Ground Control and Only Use Four Jacks?
- Q&A: Replacement Wiper Seals for Slide Outs
- Article: Still Rocking After Leveling? How to Stabilize Your RV for Good
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: How to Install E-Track in 3 Easy Steps
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Raise Your Travel Trailer Height
- Article: Trailer Lighting Requirements