Replacing Switch on Ventline Trailer Roof Vent
Updated 12/03/2018 | Published 12/01/2018
Products Featured in This Question
Question:
Not to sound dumb, but how do I get the wiring off the back of the current switch? Its like the wiring is glued to the prongs.
asked by: Ivy F
0
Expert Reply:
Most likely the wires are soldered to the existing switch # BL0108-00 on your Ventline Roof Vent.
To remove the wires you can either use a soldering iron like # PTW2000 on the wiring just enough that you can pull them free or if there is enough extra wiring you can simply cut them and reconnect them to the new switch after stripping the new ends.
expert reply by:
Chris R
0
Product Page this Question was Asked From
Replacement Mini-Rocker Switch for Ventline Ventadome Trailer Roof Vents
- Accessories and Parts
- RV Vents and Fans
- Roof Vent
- Switches
- Ventadome
- Ventline
more information >
Continue Researching
- Q&A: Recommended Replacement For A Power Switch 50 Amp Transfer Switch
- Q&A: Replacement Motor and Blades for Ventline Ventadome V3094
- Q&A: Is Fuse Required to Install Replacement Fan Motor for Ventline RV Range Hood
- Q&A: Does Solar Powered Outdoor Light Have On And Off Switch
- Q&A: Is Optronics Scare Light Motion Activated
- Q&A: Replacement Antenna for Furrion RV Backup Camera and Observation System
- Q&A: Dimensions of Ventline RV Range Hood Replacement Switch BL0108-02
- Article: Trailer Wiring Diagrams
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: How to Measure for Trailer Hitch Drop
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Testing Trailer Brake Magnets for Proper Function