Dimensions of V-Wing Bracket for Pontoon Boat Trailer
Published 11/14/2018
Question:
I need a pontoon trailer bunk bracket with a 1 inch lift, wing type bracket do you have any? 2005 24 ft McLean boat trailer
asked by: Jimmy
Helpful Expert Reply:
We do have one V-wing bracket for pontoon boat trailers, the CE Smith V-Wing Bolster Bracket for Pontoon Boat Trailers # CE26244G though I wasn't quite sure what you were referencing in terms of a one inch lift so I added a photo for you which shows the dimensions of this bracket.
It is a total of 15-1/2 inches long and measures 2-1/4 inches from the base to the bottom of the "V" and 6 inches tall at its highest point.
The CE Smith V-Wing Bolster Bracket # CE26244G is made of galvanized steel and has 7-1/2" long x 1/2" wide mounting slot dimensions; it is designed to carry a pair of 2" x 6" or 2" x 8" bunk boards and is made in the USA.
I have added a link to a video review of this bracket for you to check out as well.
Product Page this Question was Asked From
CE Smith V-Wing Bolster Bracket for Pontoon Boat Trailers - Galvanized Steel - Qty 1
- Boat Trailer Parts
- Bunks
- Bunk Bracket
- 6 Inch Tall
- 3 Inch Wide
- Galvanized Steel
- 15-1/2 Inch Long
- CE Smith
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: How To Know Which Master Cylinder Will Be The Correct Replacement For A Surge Actuator
- Q&A: How To Install Rollers On a Pontoon Boat
- Q&A: How Many Screws Are Included With The Stainless Steel Hex Lag Screw # FA74521?
- Q&A: Would 7-Way Trailer Wiring Circuit Have Amperage Rating for Powering 13 amp Horn
- Q&A: Are All 3,500 lb Axle Hub/Drums Interchangeable
- Q&A: Solution for Transporting Native Titan 10.5 Kayak
- Q&A: How To Replace 18 Foot Long Bunk Boards On a Pontoon Boat Trailer
- Article: How to Raise Your Travel Trailer Height
- Article: What To Look For When Buying Ratchet Straps