Is Factory Handle Removed When Installing Pop & Lock # PL8675 on 2019 Honda Ridgeline
Updated 10/30/2018 | Published 10/29/2018
Products Featured in This Question
Question:
will the 8675 work on this truck and can the old cover be drilled out or will I need to use the black handle that comes with the unit.
asked by: Tommy P
Expert Reply:
I checked with Pop & Lock and was able to verify that the Custom Tailgate Handle # PL8675 referenced in your question is confirmed to fit your 2019 Honda Ridgeline. When installing the system you will need to remove the factory handle on the Ridgeline and replace it completely with the black handle that comes with the kit. Also note that if your factory handle is equipped with the backup camera it can be transferred to the new one so you can continue using it.
I have attached an image of these particular steps from the installation manual that you can also take a look at.
Product Page this Question was Asked From
Pop & Lock Custom Tailgate Lock - Power - Black
- Tailgate Locks
- Lock Only
- Power Lock
- Keyed Unique
- Vehicle Specific
- Black
- Pop and Lock
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: How to Wire Pop & Lock Tailgate on Honda Ridgeline Using Wiring Behind B-Pillar
- Q&A: Does The BAKBox 2 and BAKFlip Cover Allow Access To Trunk In Honda Ridgeline
- Q&A: Installing The BakFlip F1 Hard Tonneau Cover On 2012 Honda Ridgeline
- Q&A: Will the BAKFlip G2 Hard Tonneau Cover # BAK26601 Limit Trunk Access on a 2014 Honda Ridgeline
- Q&A: Availability of Replacement Key for Pop & Lock Custom Tailgate Lock
- Q&A: Trailer Hitch Confirmed to Fit a 2022 Ford Bronco Sport
- Q&A: Recommended Bed Step For 2017 Ford F-350