Installing Edge CS2 Performance Tuner in 2007 Chevy Silverado
Updated 10/23/2018 | Published 10/22/2018
Question:
How can I put my truck back to stock and then put the tuner in 2007 Chevy 3500 duramax The tuner is a CS edge tuner
asked by: Jose
Expert Reply:
Whichever tuner you currently have installed in your truck will have instructions on how to change it back to stock.
After doing that, to install an Edge Evolution CS2 such as part # EP85350 that fits 2007 Chevy Silverado Classics with 4.8L, 5.3L and 6.0L V8 engines you only need to plug the OBDII connector into the vehicle port which is normally below the driver's side dash.
I have included a link to the installation manual of this tuner for you to check out as well.
Product Page this Question was Asked From
Edge Gas Evolution CS2 Performance Tuner- Color Screen
- Performance Chip
- Performance Tuners
- Tuner Only
- Color Screen
- No - Not California Approved
- Evolution
- Edge
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: How to Increase Towing Power in 2003 Chevrolet Avalanche 1500 with 5.3L V8 Towing 7600-lb Trailer
- Article: Converting Your RV Water Heater to Tankless
- Article: Most Popular Wheel Bearings
- Q&A: How to Use Furnace With Furrion Chill Cube on 2017 Keystone Cougar 327RES
- Q&A: Replacement Motor for Fan-tastic 8100TR
- Q&A: Wiring Instructions For A Dometic RV Water Heater Single-Panel Control Switch
- Q&A: Horsepower Gains for 2014 Chevy Silverado 5.3L with Programmer, Cold Air Intake, and Exhaust Mods
- Q&A: Edge Evolution Programmer for a 2015 Chevy Silverado 2500HD with 6.0 Liter Motor
- Q&A: Will Edge CTS3 Programmer Fit 2011 Chevy Silverado with 6.0 and Basic Bolt Ons
- Article: Performance Chips and Modules
- Article: 5 Things to Know About Weight Distribution Hitches