Availability of Topwind Jack with Wheel to Maneuver Trailer

Updated 10/16/2018 | Published 10/15/2018

Products Featured in This Question

Pro Series Round, Pipe-Mount Swivel Jack w/ Footplate - Topwind - 15" Lift - 5,000 lbs

(196)

$61.87

Rack'Em Trailer Dolly

(143)

$232.03

Trailer Valet 5X Swivel Jack and Trailer Mover - Topwind - 15" Lift - 5,000 lbs

(569)

$422.10

Question:

Do you have a top crank jack available with a wheel for use with a welded on pipe mount for a 77” x 10 PJ utility trailer weighing 1000lbs empty and 1800lbs loaded ATV and gear? Need to move around by hand in tight quarters. Would a trailer dolly work instead?

asked by: Joe

Expert Reply:

I do have a solution for you, however we do not currently have any top wind, pipe-mount trailer jacks available that utilize a wheel caster so that you can maneuver the trailer around.

For your application I recommend taking a look at the Trailer Valet 5X Swivel Jack and Trailer Mover # STC-V211. This particular jack will use the included brackets to clamp to either side of the trailer tongue instead of your welded pipe mount. This unit will not only function as a jack but it will also allow you to easily move around your trailer when needed. It features a chain drive system that is operated by an easy-to-use hand crank to drive and steer the trailer around with minimal effort. You can even use the included Drill Attachment so that you can power the unit with a cordless drill for an even easier operation. It has a topwind hand crank and a 500 pound tongue weight capacity, which is more than enough for your 1,800 pound fully loaded trailer.

I have attached a short video demonstration that you can also check out.

We do also have a standard trailer dolly with the Rack'em # RA20 that will work great to move the trailer around. It features a 500 pound tongue weight capacity and an adjustable height 1-7/8 inch hitch ball to connect with the coupler. I have attached a short video demonstration on this dolly that you can take a look at as well.

expert reply by: Chris R