Picking Out Replacement Seals for Valterra 1-1/2 inch Diameter Waste Valve
Published 09/12/2018
Products Featured in This Question
Question:
I have a valterra 1 and 1/2 inch gate valve for hot tube.model # 6100 on valve. needs seals. wait do i need to order
asked by: Michael A
0
Expert Reply:
The correct Valterra RV waste valve seals for 1-1/2 inch diameter valves is part # T1001-7VP for standard valve like part # T1001A or the part # T1001-9VP for if you have the Bladex style like # T1001VP.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Valterra Bladex RV Waste Valve Seals - 1-1/2" - Qty 2
- Accessories and Parts
- RV Waste Valves
- Waste Valve Parts
- Seals
- 1-1/2 Inch Diameter
- Valterra
more information >
Continue Researching
- Article: We Used 34 RV Tow Bars, and These are the Best for Flat Towing
- Q&A: Replacement Red Oval Trailer Light Lens Marked SAE P2 86
- Q&A: Travel Trailer Steps With Lift Assist Like Lippert SolidStep Lift Assist LC733939
- Q&A: Can the Follow-Leg Be Replaced On an Atwood Landing Gear Set
- Q&A: Replacement Remote for MaxxFan RV Roof Vent
- Q&A: Replacement Seal For National Grease Seal # 5970
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Recommended SAE Wired 7 way Trailer Plug
- Q&A: Testing a Vehicle Side 7-Way Trailer Connector for Proper Function
- Article: How to Install an RV Awning From Scratch
- Article: Replacing RV Awning Fabric: Your Step-by-Step DIY Guide
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Trailer Wiring Diagrams