How to Secure Entry Handle for RV
Published 09/07/2018 >
Question:
when i lift the folding handle it comes out of the brackets very easily, im concerned about it coming out on the road. suggestions?
asked by: Steve M
Helpful Expert Reply:
You referenced the Camco Fold-Away RV Grab Handle # CAM42176 but I am not sure that is what you have in your picture as the mounting brackets aren't supposed to have those indentions. There is actually a spring on the Camco part you mentioned that holds it into place.
For your application I recommend maybe trying to use a thick rubber band to steady the handle while you are driving, completely taking the handle off, or even just replacing the unit.
Product Page this Question was Asked From
Camco Fold-Away RV Grab Handle - Aluminum - White
- RV Handrail
- Grab Handles
- Folding
- Aluminum
- Bolt-On
- 28 Inch Long
- Silver
- Camco
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Will Lend-a-Hand Mini fit existing Winnebago grab handle holes? Mounting pattern and install guide
- Q&A: Enclosed Trailer Side Door Frame and Trim
- Q&A: Looking For Hand Rail Solution For 2020 Grand Design Imagine 2970RL With MORryde Step
- Article: What RV AC Will Work With Your Setup? Avoid Costly Mistakes Before You Order
- Q&A: Replacement For Kwikee Control Module 1510000140
- Q&A: Replacement Landing Gear For Bulldog 1082816-83 When Screw Head Broke Of Jack Leg
- Q&A: Recommended Replacement for Atwood GC10A-4E RV Water Heater
- Q&A: Dimensions and Amp Draw of the 15 cu ft Norcold RV Refrigerator w/ Freezer NC67VR
- Article: How to Replace or Install an RV Roof Vent
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: What is the Best Trailer or RV Storage Cover
- Article: The Ultimate RV Camping Checklist for Your First Year RVing
- Article: Trailer Wiring Diagrams




