Can 4,000 lb Floor Jack with Stands # PTW1605 Be Used When Storing Trailer for Jack Stands
Published 08/28/2018
Question:
To preserve the tires am I correct that I will need 4 stands during long term storage?
asked by: Sharon B
0
Expert Reply:
The trailer jack would hold the front of the trailer and then the two stands of the 4,000 lb Floor Jack with Stands # PTW1605 would hold the other end of the trailer and keep it stable from left to right. You would not need a second set of stands.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Holiday 2025 | Best Gifts for Towers
- Q&A: Could Trailer Jack # TJB-2001SB Fit Same 2.5 inch Pipe Mount as Bulldog Jack
- Q&A: Locking Hitch Pin Compatibility Between Bike Rack Manufacturers
- Q&A: Are Any Trailer Tires Made in the USA
- Q&A: Comparing Trailer Tire Sizes 16.5x6.5-8 and 165/65-8
- Q&A: Replacement Leaf Spring for 2018 Clipper 17bh
- Q&A: Which Way Should Bow of Trailer Axle Face When Installed on Trailer
- Q&A: Changing Spring Hangers To Raise Or Lower A Trailer
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Trailer Wiring Diagrams
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: How to Measure Your Trailer Wheel Bolt Pattern