How to Access Mounting Hardware on the Camco Fold-Away RV Grab Handle # CAM42176
Updated 08/27/2018 | Published 08/25/2018 >
Question:
Mine is in need of tightening. Any suggestions on how to remove the plastic piece so I can access the screws? Thanks!
asked by: Dean R
1
Helpful Expert Reply:
Basically, squeeze and pull. The little caps on the mounts for the Camco Fold-Away RV Grab Handle # CAM42176 sort of snap in. Squeeze at the top and pull out and down because the caps sort of hinge on a tab on the mount. The caps can't go straight down or out so pulling the top down and outward some will then allow you to pull the caps from the mounts.
expert reply by:
Michael H
1
Product Page this Question was Asked From
Camco Fold-Away RV Grab Handle - Aluminum - White
- RV Handrail
- Grab Handles
- Folding
- Aluminum
- Bolt-On
- 28 Inch Long
- Silver
- Camco
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Is There a Way to Get Replacement Caps/Covers for the Camco Fold-Away RV Grab Handle
- Q&A: Will Lend-a-Hand Mini fit existing Winnebago grab handle holes? Mounting pattern and install guide
- Q&A: Enclosed Trailer Side Door Frame and Trim
- Q&A: Looking For Hand Rail Solution For 2020 Grand Design Imagine 2970RL With MORryde Step
- Article: What RV AC Will Work With Your Setup? Avoid Costly Mistakes Before You Order
- Q&A: Replacement For Kwikee Control Module 1510000140
- Q&A: Replacement Landing Gear For Bulldog 1082816-83 When Screw Head Broke Of Jack Leg
- Q&A: Recommended Replacement for Atwood GC10A-4E RV Water Heater
- Article: How to Replace or Install an RV Roof Vent
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: The Ultimate RV Camping Checklist for Your First Year RVing
- Article: What is the Best Trailer or RV Storage Cover
- Article: Trailer Wiring Diagrams


