Trailer Hitch and Wiring for a 2009 Volvo XC90 with Dual Exhaust  

I went to the warehouse and measured the Brophy 2-Inch Hitch Ball, part #SC23-C. The length of the shank from the underside of the platform that sits on the ball mount is 2-1/2 inches. The threaded portion of the shank measures 2-1/8 inch. I have…

To only send power to the 12 volt charge line circuit on your 2001 Chevrolet Suburban you need to add a Relay Switch #BDW42035. With this switch you will be able to connect it to an ignition circuit wire that only receives power when the ignition…

It is possible to use a 7-way vehicle end connector such as #PK12-707E to hook up to a stand-alone battery for your lights. You would need to connect by using 10 gauge wire, #10-2-1, and if you use a deep cell battery as you suggested, a pair of ring…

You will need a battery isolator, like Battery Isolation Solenoid, part #PK5231201, if you plan on leaving the trailer connected to the truck when the truck is off. If you unplug the 7-Way, the trailer battery cannot drain the truck battery. If you…

To install the Tekonsha Prodigy RF Brake Controller #TK94FR brake controller on your 2010 Volvo XC90 and trailer you have established an excellent plan. You are correct in choosing the Tekonsha Prodigy RF Brake Controller for your vehicle that is…

Basically if you look at the rear of your 2019 Audi Q5 and you don't see a trailer connector then you don't have one from the factory. Worst case scenario you can call your local dealer with your VIN and they will be able to confirm either…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

Installing a trailer hitch on your 2004 Volvo XC90 is not a huge project by any means. To install a hitch like the Draw Tite hitch that fits your vehicle part #75152 is relatively very easy. I attached an install video that shows this hitch installed…

Hello Agustin, Great question. For your 2011 Volvo XC90 you are correct that you will want to start with the 4-flat wiring, the Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector #C56045 will be a great fit. Since you already…

The correct hitch for carrying a bike rack with your 2006 Volvo XC90 would be the Curt Hitch part #13559. The reason it is called a trailer hitch is because this product was initially designed for people to tow trailers with their tow vehicles. Later…

Hey Ryan, The Draw-Tite Trailer Hitch Receiver #75152 is on extended backorder with no expected in-stock date so it's harder to find on the site to prevent people from purchasing it and then being disappointed that they have to wait forever. The…