Replacement V-Wing Bolster Bracket for Pontoon Boat

Updated 08/07/2018 | Published 08/06/2018

Question:

Hello, I have a 2002 Lowes 22ft pontoon with rusted out bunk brackets. They measured 11 W x 5 H each. I am attaching a photo of mine. Was wondering if you think these should work on my trailer and if they will stick out further than the origninals. I also thought about just buying one for now to see if it would work as I would need ten of them. Also if it did not work could I return it. Also do you sell any side rail supports similar to the one in my picture. Thanks Thanks

asked by: David F

Expert Reply:

What you sent in a picture of is a V-Wing bolster bracket like the # CE26244G that you referenced. These are slightly different from what you have that are 11 inches wide by 5 inches high. These are 15-1/2 inches wide by 6 inches tall which is pretty close. Also these are designed for 6 or 8 inch wide bunk boards. When you replace the boards you'll need to use either width and you'll be set. I attached a link to our return policy page also.

We do not have anything like what's in your second picture though.

expert reply by: Jameson C