What is the Inside Dimension of Hopkins 3/8 Inch Wire Loom and is it Split Down One Side
Updated 09/30/2011 | Published 09/29/2011 >
Question:
2004 Excalibur trailer, 1 1/4 inch strandard hitch 1.Do you measure 1/2 inch and 3/8foot wire loom by the inside or outside diameter ? 2.Is the wire loom split on the side or do you have to thread the wire through it ? Thanks-
asked by: George W
0
Expert Reply:
I went out to the warehouse and pulled a Hopkins Wire Loom, # 39035, to take some measurements for you. The 3/8 inch diameter is the inside diameter of the loom. And it is already split the entire 10 foot length of the loom so you would not have to fish wires through it.
expert reply by:
Michael H
0
Continue Researching
- Q&A: What Trailer Hitch and Wiring do I Need for My 2026 Toyota Grand Highlander?
- Article: Which Hitches are Made in the USA
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Most Concealed Hitch for a 2022 Toyota Highlander Limited
- Q&A: Can You Hook Power Wire Up From Curt Harness to In-Bed 12 Volt on 2022 Ford Maverick
- Q&A: Why Does Curt Wiring Power Lead Need to Run to Battery on 2022 Ford Maverick
- Q&A: What 2022 Ford Maverick Battery Should Curt T-Connector 12V Power Be Connected To
- Q&A: Does Power Wire of Curt Trailer Wiring harness for 2024 Ford Maverick Hybrid Run to Back Seat
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: Trailer Lighting Requirements
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Brake Controller Installation: Starting from Scratch