Width Between Mounting Holes of Hopkins Mounting Bracket
Published 08/02/2018
Question:
Can you please tell me the width of the holes for mounting this product? Thank you in advance for your help.
asked by: Greg
0
Expert Reply:
If you take a look at the accompanying diagram you can see the widths between the mounting holes of the Hopkins Mounting Bracket for 4-Way, 5-Way, or 6-Way Round Trailer Connectors # HM48605.
This bracket comes with mounting hardware - screws, nuts and washers - that will fit the actual mounting holes themselves.
expert reply by:
Kyle S
0
click to enlarge
Continue Researching
- Q&A: Where Does Trailer Connector Install On Draw-Tite Trailer Hitch Receiver 75956?
- Article: Flat Towing Package for 2014-2018 Jeep Grand Cherokee
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Demco SBS Air Force One Replacement Parts for Poor Vacuum on 2018 Jeep JK Rubicon
- Q&A: Seat Adapter and Stop Light Switch Kit for BrakeMaster System on a 2014 Jeep Grand Cherokee Overland
- Q&A: Receiver Hitch Recommendation for 1986 Ford F-150 with Step Bumper
- Q&A: Trailer Wiring for 1986 Ford F-150 that Uses Spade Connectors for Connection
- Q&A: Recommended Diode for Charging Line From Motorhome to Towed Vehicle (Toad)
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: Must-Have Flat Towing Components